If the Wireless Printer Does Not Respond

If the WLAN printer does not wake up, it is connected to the Windows port configuration. The tip provides remedy.

Your multifunction device or printer is integrated into your home network. This allows you to print from any device in the same WLAN. Theoretically. In practice, you have the problem that your printer stops responding as soon as it enters sleep mode.

When you are at home, you can wake up the printer by tapping too short on its touch panel or pressing any button on the control panel. Then wait a few minutes for the device to activate the WLAN connection completely. You can usually see this on the WLAN symbol, which only flashes a few times until it is lit continuously.

Test: The best multifunctional devices for printing, scanning, copying, faxing

However, this method is neither satisfactory nor practicable. You can also use the HPePrint to control the printer. If you use such a service, you are not on the spot to manually set the printer to operating mode. Alternatively, you can deactivate the idle mode in the menu of the printer model. To do this, go directly to the multifunction device or printer in “Setup” or “Setup” and select Power management idle mode. Set the selection to “Never” so that the device can not switch off. Again, this path is a makeshift and not really in the sense of the inventor. After all, you want to save energy, do not waste. Depending on the pressure model, there is also a shutdown function of the rest mode.

Disable SNMP: This is why the SNMP function is disabled. The Simple Network Management Protocol is used to monitor and control network elements such as routers, switches, or printers from a central station. The protocol sends data packets. However, the printer does not recognize it as a print job and ignores it. If you disable this protocol, the printer will go into idle mode when not in use, but will respond immediately if a print job arrives. It switches to the operating mode and performs the task. To disable the protocol, go to “Devices and Printers” on the Windows computer and select your default printer. Right-click on the “Print Properties”. Under the Ports tab, locate the port to which your printer hangs. Select the port – such as HP Standard TC / IP Port. Click “Configure…”.Then remove the checkmark “SNMP Status Enabled” and confirm your entry with “ok”. To make sure that Windows accepts the input, restart the computer. For some printer models, you must also deactivate the network protocol on the device itself. You will find it in the network settings. Repeat the procedure for each computer or laptop that you want to access the wireless printer.

Create configurable port: Some printer ports can not be easily configured. Rather, you receive the message “Connection configuration error. This operation is not supported”.To disable SNMP, create a new printer port by clicking Add. Then select “Standard TC / IP Port” under “Available port types:”, click on “New port…” and follow the Windows routine. If the printer port is added, it can be configured as described.